Original Chill M

It is important with all hot tubs to be placed on an even surface that can bear the whole weight of the tub once full of water. This foundation must be level, which can be achieved with various aggregates such gravel, stone and concrete.

When placing the hot tub consider possible places to drain your bathing water too. If needed you can lead off the water with an outlet hose. The water discharge valve is located on the opposite side of the stove to which you can attach Kirami outlet hose. The hose has 38 mm inner diameter.

Take fire safety in consideration when placing the hot tub. Always ensure that the chimney is located away from flammable materials. Remember to check the surrounding including the distance both sideways and vertically to avoid the risk of fire.

During wintertime, when the tub is not in use please ensure the tub is emptied of all water. If water is left in the tub during winter there is a risk of freezing temperatures, which can cause your bathing water to freeze and expand which can cause the drainage pipe to crack.

The bottom plugs and exhaust valves need to be left open so that any water collected to the tub will discharge.

If you are wanting to use your tub over a couple of days during the wintery season you must try to maintain sufficient heat in your water to avoid it freezing. This may mean using an insulated cover and monitoring the water temperature to see if you need to use your heater to prevent the water temperature dropping to freezing.  

It is important before lighting up the hot tub’s heater to check the water level inside of the tub. The heater must not be lit when the tub is empty or the water level is below minimum fill limit. The minimum fill limit is marked on the heater and in the instructions.

When emptying your tub after use, Do not discharge the water until the fire and embers in your burner have burnt out completely. 

In order to help keep the hot tub clean you can buy a model-specific cover. You can also take care of the cleanliness and hygiene of the tub by washing and drying it carefully and often.

Washing can be done, with a mild disinfectant. Kirami sells chemicals that can be used for keeping the water clean. When using chemicals, the pH of the water should always be monitored and kept in the given limits, i.e. 7.0-7.6. to test your pH levels you require litmus strips. They are available with a water treatment pack from Kirami.

If this is the hot tub for you, proceed to customise your purchase - choose the outer and inner finishes along with adding LED lights to your tub (where possible).