Kirami Wood Treatment Oils & Stains
Product description
Keep your Kirami wood fire hot tub looking a new as possible with our range of wood treatment products.
Stained Spruce surfaces can be treated with Teknos Teknoshield or Woodex Aqua stain.
Thermowood and Red Cedar can be treated with wood oil with UV filter.
Composite panels only need to be washed every once in a while.
When treating the tub panels, you can remove the outer hoops or cover them with adhesive tape during treatment, immediately removing any splashes or runoffs.
Maintenance of your hot tub ensures a longer lifespan. With these stains and oils you can return the hot tub to the original Kirami colour. Stains and oils are both protective and decorative.
A 1 litre tin is sufficient for hot tubs with a diameter of 170cm to 220cm. Oils are only available in 2.5l tins. This will be sufficient for multiple tubs or years of treatment assuming stored in a cool dry place.
Preparation
Cedar Oil and Thermowood Oil work best on unfinished timber. Previous finishes which stop Oil penetrating into the timber (e.g. paint and other ‘closed’ finishes) must be fully removed prior to application. Previous porous finishes can be lightly sanded before overcoating. When overcoating a previously finished surface, a trial application is essential. Flaking or peeling finishes must be fully removed prior to application. Ensure the timber is dry and free from possible contaminates e.g. algae, grease, dirt, dust etc. Timbers susceptible to decay, mould and fungi should be treated first with a suitable preservative. We advise that when using Oil, sufficient product is purchased to complete the whole project and when more than one tin is required it is advisable to mix them together before use. Timber must have a moisture content below 18%. Temperature must be between 8º and 25º during application and drying. We strongly recommend a trial application prior to starting the project.
Application
Stir tins thoroughly, before and during use. Use a brush or roller to evenly apply Oil in the same direction as the wood grain. Pay particular attention to end grain, on end grain apply liberally. If possible, treat all sides of the timber for the first coat. After approximately 12 hours the first coat can be overcoated. Apply with a brush or roller a second coat of Oil. After the second coat leave for approximately 12 hours to dry. Oil is not a surface building product.
Red Cedar Oil Safety Data Sheet
Thermowood Oil Safety Data Sheet
--600.png "Floating Thermometer")